CENTFOS SWQ-H submersible sewage pump

CENTFOS SWQ-H Submersible Sewage Pump

Model: SWQ-H

The CENTFOS SWQ-H submersible sewage pump is suitable for discharging most types of sewage, purified treatment water and industrial wastewater, especially untreated sewage containing long fibres and solid particles, and activated and digested sludge water.

SWQ-H Submersible Sewage Pump

Introduction

Typical applications include municipal engineering, industrial sewage discharge and sewage treatment projects. The CENTFOS SWQ-H range covers speeds of 740, 980, 1,450 and 2,900 r/min and outlet diameters from DN50 to DN600.

Its flow-through components give a wide high-efficiency zone and a wide operating range, and the motor and hydraulic components are directly connected, without the need for shaft alignment.

Key Features
  • Wide high-efficiency zone and wide operating range
  • Single-channel or double-channel impeller
  • Large-channel pump body with a wide, unobstructed flow channel
  • Two independent single-face mechanical seals in series
  • Enlarged oil chamber
  • Optional oil-chamber leak detection sensor
  • Motor and hydraulics directly connected, no shaft alignment
Technical Specifications

Parameter

Value

Maximum rated flow

4,000 m³/h

Maximum rated head

110 m

Speeds

740 / 980 / 1,450 / 2,900 r/min

Outlet diameter

DN50–DN600

Standard cable length

5 m

Rotation

Clockwise, viewed from the motor end to the pump end

Design Characteristics
Hydraulic Design
  • Flow-through components with a wide high-efficiency zone and a wide operating range
  • Single-channel or double-channel impeller with a large-channel pump body
  • Wide, unobstructed flow channel for easy passage of solid matter and fibres
Sealing System
  • Two independent single-face mechanical seals installed in series, mounted internally and lubricated by the oil in the oil chamber
  • Special spiral groove or small gap helps prevent solid particles from depositing on the pump-side mechanical seal
  • Enlarged oil chamber lubricates the mechanical seal, carries away bearing heat and adds protection against liquid penetration
Monitoring and Control
  • Optional leak detection sensor in the oil chamber, which raises an alarm and stops the pump through the electric control cabinet when leakage reaches a set concentration
  • With a dedicated electric control cabinet and liquid level float switch: monitoring and alarm of leaks and winding overheating; short-circuit, overload and phase-loss protection; automatic start, stop and alternation
Maintenance
  • Motor and hydraulic components directly connected, with no shaft alignment required
  • Convenient disassembly and on-site maintenance, reducing downtime and maintenance costs
Operating Conditions

Parameter

Condition

Medium density

≤ 1,050 kg/m³

Motor protection class

IP68

Insulation class

F

Flange pressure grade

0.6 MPa (DN200 and below); 1.0 MPa (DN250 and above)

Motor exposed above liquid

Not more than half of the motor height

Operating range

Within the rated head, so the motor is not overloaded

Applications

CENTFOS SWQ-H pumps are suitable for:

  • Most types of sewage
  • Purified treatment water
  • Industrial wastewater
  • Untreated sewage containing long fibres and solid particles
  • Activated and digested sludge water
  • Municipal engineering
  • Industrial sewage discharge
  • Sewage treatment projects
Advantages
  • Wide high-efficiency zone and operating range
  • Easy passage of solid matter and fibres
  • Stable operation of the pump-side mechanical seal
  • No shaft alignment needed
  • Reduced downtime and maintenance costs